I am trying to install and use NI cDAQ 9174 with NI 9862 CAN modules. But for some reason cDAQ 9174 is not recognized in MAX or signal express and am unable to configure it. It shows up in Windows device manager as "cDaq-9174" under the heading "National Instruments Device".
I uninstalled and installed DAQmx (Version 9.7.5 and 9.8) and XNET 1.8 drivers multiple times but its the same deal. I am using Windows 7, Labview 2010 and TEststand. I checked some other realated posts and tried the solutions, but no luck in getting it working. The chasis works fine on another PC, so the hardware should be working fine.
I have attached my technical report from MAX for more info. I have also tried resetting my configuration data through MAX as well. I cannot afford to reinstall WINDOWS in this PC. Any suggestion would be helpful. Thanks.